You picked out the perfect faucet. Brushed nickel, pull-down sprayer, the works. Now it's sitting in the box on your kitchen counter, and the gap under the sink looks a lot tighter than it did at the store. That's where most folks in Colton call us.
Faucet swaps look simple on the YouTube video. Then you crawl under there with a flashlight and find corroded supply lines, a shutoff valve that won't budge, and a mounting nut rusted to the deck. On homes around here, that's the norm, not the exception.
We install kitchen, bath, and utility faucets clean and leak-free. No drips under the cabinet two weeks later. No water spots on the floor. Just a faucet that works the day we leave and keeps working.
Why a Quick Faucet Swap Turns Into a Headache
A lot of Colton homes were built in the 1950s and 60s, and the plumbing under the sink shows its age. The shutoff valves under there often haven't been turned in twenty years. Try to close one to swap a faucet and it either seizes up or starts weeping at the stem. Now your simple faucet job needs a valve too.
Then there's our hard water. The Inland Empire is rough on fixtures, and scale builds up everywhere — inside the supply lines, around the mounting nuts, packed into the old faucet's threads. That crust is why the existing faucet won't come loose without a fight, and it's why a cheap install that reuses tired parts starts dripping fast.
We handle the whole picture, not just the part you can see. New supply lines, a fresh shutoff valve if yours is shot, the right washers and seals, and a mounting that's torqued down so the faucet doesn't wobble. We test under pressure before we pack up, so the only thing you notice afterward is that it turns on and shuts off clean.
Signs It's Time to Replace That Faucet
- It drips after you shut it off, even after a new washer or cartridge
- The handle is stiff, grinds, or spins loose without controlling the water
- You see green or white crust building up around the base or spout
- Water pools at the base of the faucet or seeps under the sink
- Low or uneven flow from scale built up inside the spout and aerator
- The finish is pitted, peeling, or just looks tired next to your remodel
